P0BBC
Hybrid/EV Battery Voltage Sense Z Circuit Intermittent/Erratic
P0BBC closes the generic block of 26 cell voltage channels from A to Z; after it J2012 moves on to pack-level codes such as P0BBD and P0BBE. The code is meant for a Z signal that is unstable rather than absent. There is no manufacturer documentation for it: GM monitors channel Z from the 2011 Volt to the 2019 battery energy control module, but always with P0BB8 to P0BBB only, and no table contains an intermittent monitor. Its basis is CARB 1968.2, which requires battery voltage sensors of hybrid storage systems to be checked and faults to be narrowed down to the smallest replaceable unit. Should it appear, contacts that fail under vibration or heat cycling are the logical starting point.
Possible causes
- Intermittent contact on sense lead Z high
- Joint at channel Z opening with heat cycling medium
- Corrosion in the Z sense connector low
Symptoms
- Warning lamp appearing irregularly
- Occasional brief loss of electric drive power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BBC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.