P0BAD
Hybrid/EV Battery Voltage Sense W Circuit Intermittent/Erratic
P0BAD is reserved for a W signal that drops out or jumps for short moments instead of failing outright. No manufacturer documents the code publicly. GM monitors channel W in several programmes, from the 2011 Volt to the eAssist and the 2019 tables, but only through P0BA9 to P0BAC; none of them contains an intermittent test. The slot exists because J2012 gives every sense channel five codes and CARB 1968.2 requires the battery voltage sensors of a hybrid energy storage system to be monitored with fault codes that point to the smallest replaceable part. If a vehicle did store it, the usual suspects would be a crimp or connector that loses contact under vibration or with temperature changes.
Possible causes
- Loose or fretting connector pin on lead W high
- Crimp on lead W opening with temperature changes medium
- Cracked solder joint on the monitoring board input W low
Symptoms
- Warning lamp that comes and goes
- Occasional short power reduction
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BAD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.