P0B98
Hybrid/EV Battery Voltage Sense S Circuit High
P0B98 marks a sense S value that is too high to be a cell voltage. The thresholds vary with the battery chemistry and controller: GM's 2016 Volt and 2019 battery controllers flag 4.8 V or more after 1.4 s in 2 s (Type A), the 16OBDG02 programme 4.90 V in 14 of 18 samples (Type A), and the eAssist mild hybrid more than 4.65 V in 7 of 10 samples with the 12 V supply above 8.8 V (Type B). On the 2012 two-mode trucks S is NiMH block 19 and its limit is 23 V, 15 of 20 samples, Type B. Like the low test, the high test waits until open sense line faults are ruled out. The fix is usually wiring or the monitoring board; a truly overcharged cell is rare but must be excluded.
Possible causes
- Sense lead S shorted to a higher cell or busbar high
- Measuring chip reading channel S incorrectly medium
- Real overvoltage of the cell or block on channel S low
Symptoms
- MIL and service hybrid system message
- Charging and regeneration limited
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0B98
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.