P0B95
Hybrid/EV Battery Voltage Sense S Circuit
P0B95 reports that the sense S lead, channel nineteen, no longer connects its cell reliably to the monitoring electronics. GM programmes with a separate battery sensor module (16OBDG02) measure this directly: after each normal reading the balancing gates switch in a test pattern, current flows through the sense wires and the voltage drop is turned into a line resistance. Above 30.00 (the table gives no unit) in 7 of 9 samples at 100 ms, the code sets as Type A. GM's eAssist mild hybrid instead needs lines N and N-1 both under 1.4 V plus a jump of more than 0.5 V in 200 ms, 7 of 10 samples, Type B, and stays quiet while P1B37 is active. The 2019 lithium-ion controller uses its seven cases with 0.8 s in 1.6 s.
Possible causes
- High resistance in sense lead S from corrosion or a loose terminal high
- Sense lead S broken at the cell connector medium
- Defective input of the battery sensor module for channel S low
Symptoms
- MIL and hybrid or EV warning
- Vehicle may refuse ready mode
- Cell balancing no longer effective
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0B95
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.