P0B63
Hybrid/EV Battery Voltage Sense I Circuit
Channel I is the ninth sense input of the battery monitoring chain, and P0B63 reports that its circuit is open. GM shows how differently this can be detected. The BAS Plus mild hybrid (table 13OBDG05C) watches the voltage of line N and its neighbour N-1: if both drop under 1.4 V and change by more than 0.5 V within 200 ms, 7 of 10 samples set the code, Type B. The newer battery energy control module of the 2019 tables relies on neighbouring cells drifting 1.3 V apart, a balancing test below 36 mV or a splice voltage, all within 0.6 s, Type A. Ford lists P0B63 among the open-line codes behind a no-start on the 2019-2020 Fusion plug-in hybrid and replaces the traction battery.
Possible causes
- Broken channel I sense wire, crimp or cell tap high
- Internal traction battery fault, pack replacement (Ford Fusion PHEV) medium
- Corroded or loose connector at the cell monitoring board low
Symptoms
- Vehicle will not start or enter ready mode
- Service hybrid or EV system warning
- Electric mode unavailable
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0B63
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.