P0B39
Motor Electronics Coolant Pump B Control Circuit Low
P0B39 sets when the control signal of motor electronics coolant pump B is lower than the controller expects, usually a short to ground on the command line or a pump input that pulls the line down. On a low-side switched or PWM line the module sees the voltage stuck low while it commands the pump off. No manufacturer documents P0B39 publicly. Pump B is in service at FCA (Compass and Renegade 4xe, performance code P0C74), and Ford stores the pump A codes P0A06 and P0A07 in the PCM of the 2020 Explorer and Aviator hybrids. CARB requires these inverter cooling outputs to be checked for circuit faults. Open and high faults are P0B38 and P0B3A; running faults use P0C74 and P2D05 ff.
Possible causes
- Control wire shorted to ground, often chafed at brackets high
- Pump electronics pulling the control input low medium
- Coolant or water in the pump connector medium
- Driver stage in the controlling module faulty low
Symptoms
- MIL and hybrid or coolant warning
- Pump runs permanently or not at all, depending on circuit design
- Power limitation at high load or heat
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0B39
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.