P0B36
High Voltage Service Disconnect Circuit High
P0B36 sets when the service disconnect detection signal stays above its upper limit. With a pulled-up input this usually means a short to a voltage source or a missing coding element in the plug; on some designs an open loop also reads high, so manufacturers separate it with P0B37 only where they can tell the cases apart. Patents from Ford and Lear show the detection loop as a low-voltage circuit that closes through the plug and is read by a battery or vehicle controller. No manufacturer documents P0B36 publicly. CARB requires such hybrid inputs to be monitored for out-of-range values. Low and performance faults are P0B35 and P0B34. The high-voltage system normally stays switched off.
Possible causes
- Detection loop wire shorted to a supply voltage high
- Open loop or missing contact read as high signal medium
- Wrong or damaged service disconnect plug without proper coding low
- Battery controller input stage fault low
Symptoms
- Vehicle not ready to drive
- MIL and high-voltage warning on
- Charging blocked
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0B36
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.