P0B20
Hybrid/EV Battery Pack Voltage Sense D Circuit Low
P0B20 sets when pack voltage measurement D falls below its plausible minimum. The cause is usually electrical: a sense lead shorted to ground, an interrupted fuse or resistor in the measurement path, or a damaged controller input. No manufacturer documents P0B20 publicly. GM shows the analogous check on channel A, where its BECM sets P0ABC once pack-side voltage stays under 24 V for 1.6 s within 2 s, Type A, one trip. CARB requires out-of-range monitoring of battery voltage sensors in hybrid storage systems. The high counterpart is P0B21, plausibility faults are P0B1F. An implausibly low reading can block precharge, so the vehicle may not become ready.
Possible causes
- Sense lead of channel D shorted to ground high
- Fuse or resistor in the sense path open medium
- Measurement input of the battery controller defective medium
Symptoms
- Vehicle may not reach Ready or may shut down the high-voltage system
- MIL and hybrid/EV system warning on
- Battery power limited, reduced electric drive or assist
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0B20
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.