P0B1E
Hybrid/EV Battery Pack Voltage Sense D Circuit
Voltage sense D is the fourth and last pack voltage measurement in the SAE J2012 scheme. P0B1E is its general circuit code: the battery controller treats this input as electrically faulty, for example open or without a usable raw signal. The assignment of D to a specific measuring point is manufacturer-specific. No manufacturer documents P0B1E publicly. GM illustrates the monitoring on channel A, comparing pack-side voltage with limits and with the summed cell voltages (P0ABB to P0ABD). CARB requires battery voltage sensors of hybrid storage systems to be monitored like other inputs. Detailed fault types of channel D are P0B1F to P0B22. High-voltage operation is usually restricted.
Possible causes
- Voltage sense lead D or its fuse open high
- Sense connector loose or corroded medium
- Measurement input of the battery controller defective medium
Symptoms
- MIL and hybrid/EV system warning on
- Battery power limited, reduced electric drive or assist
- Vehicle may not reach Ready or may shut down the high-voltage system
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0B1E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.