P0B09
Electric/Auxiliary Transmission Fluid Pump A Motor Supply Voltage Circuit/Open
P0B09 concerns the power feed of auxiliary pump A's motor: the controller sees no valid supply voltage, usually because the circuit is open. GM documents it for its 2012-13 eAssist mild hybrids (BAS Plus): the hardware input reports an out-of-range voltage flag on the auxiliary pump circuit, enabled with ignition voltage above 9 V; failing for at least 0.375 s within a 1.2 s sample sets P0B09 as Type B, MIL after two trips. A related GM check, P2797, verifies during auto-stops that the pump draws power and that turbine speed does not flare on restart. A Hitachi patent on a battery-fed sub-oil pump shows the controller inhibits engine auto-stop when pump current behaves abnormally. Typical results: no auto-stop and a lamp. P0B0A/P0B0B are the low and high variants.
Possible causes
- Blown fuse or open relay in the pump supply high
- Open supply wire or loose terminal at the pump connector high
- Poor ground connection of the pump motor medium
- Voltage sensing input in the controller faulty low
Symptoms
- Engine auto-stop no longer occurs
- MIL after two drive cycles
- Shift flare or delayed drive engagement on restart
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0B09
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.