P0B08
Electric/Auxiliary Transmission Fluid Pump Motor Phase W Current High
P0B08 is set when the current in phase W of the auxiliary transmission fluid pump motor rises above the permitted limit. No manufacturer documents this exact code in public sources. In GM's 2016 Volt calibration the equivalent protection is P0C28, which fails on any phase above 35 A or on a d-axis current below a temperature-dependent limit, both within milliseconds to protect the IGBTs. A W-specific high code points to a short in the W lead or winding, a binding pump or a sensing error; the Hitachi patent shows the W value may be calculated rather than measured directly. CARB requires such output drivers to be monitored for circuit faults. The pump shuts down, so start-stop and electric driving are restricted. P0B07 is the low side, P0B02 and P0B05 phases U and V.
Possible causes
- Phase W lead shorted to another phase or to ground high
- Pump binding mechanically, raising motor current medium
- Current sensing in the pump inverter reads too high medium
- Shorted turns in phase W of the pump motor low
Symptoms
- MIL and transmission or hybrid warning
- Auxiliary pump shuts down, auto-stop disabled
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0B08
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.