P0B06
Electric/Auxiliary Transmission Fluid Pump Motor Phase W Current
P0B06 is the general current fault for phase W of the auxiliary transmission fluid pump motor. No manufacturer publishes a monitor description for this exact code. GM covers phase W in its Volt, ELR and CT6 calibrations with the low-side code P0B07 and treats overcurrent on any phase as P0C28. CARB requires hybrid and transmission components whose failure affects emissions or other monitors to be checked for circuit faults and rationality, which is why manufacturers can use the general code for implausible readings. The Hitachi sub-oil pump patent describes a sinusoidal drive whose W current is calculated from a single bus shunt, so wiring, sensing and the power stage are all suspects. The pump stops and auto-stop is blocked. P0B07/P0B08 are the low and high variants, P0B00 and P0B03 phases U and V.
Possible causes
- Poor contact in the phase W lead or pump connector high
- Current sensing in the pump inverter faulty medium
- Phase W power stage in the pump control module faulty medium
- Winding fault in phase W of the pump motor low
Symptoms
- MIL or transmission/hybrid warning
- Engine keeps running at stops, no auto-stop
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0B06
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.