OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0B02

Electric/Auxiliary Transmission Fluid Pump Motor Phase U Current High

P0B02 reports excessive current in phase U of the auxiliary transmission fluid pump motor, an overcurrent condition that the pump inverter must cut off to protect its switches. No manufacturer documents this exact code publicly. GM handles the same case differently: on the Volt and later hybrids it sets P0C28 when the absolute current of any phase exceeds 35 A for a few milliseconds, Type A. A phase-specific high code therefore points to a shorted U lead, a shorted winding, a jammed pump or a U current sensor reading too high. The Hitachi idle-stop pump patent shows phase currents being reconstructed from one bus shunt, which makes a sensing error a real candidate. The pump usually stops; auto-stop or electric driving is blocked. P0B01 is the low side, P0B05 and P0B08 the same fault on V and W.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / 02

Possible causes

  • Phase U lead shorted to another phase or to ground high
  • Pump binding mechanically, raising motor current medium
  • Current sensing in the pump inverter reads too high medium
  • Shorted turns in phase U of the pump motor low

Symptoms

  • MIL and transmission or hybrid warning
  • Auxiliary pump shuts down, auto-stop disabled
  • Harsh or delayed engagement after an engine stop

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0B02

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication