OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0AF4

Drive Motor Inverter Temperature Sensor B Circuit Low

P0AF4 reports a signal of inverter temperature sensor B below the valid range. GM uses an NTC thermistor with a pull-up, so a low voltage reads as an inverter far hotter than possible, usually from a short to ground or an internal sensor fault in the motor B inverter. GM's thresholds: above 170 °C for 2.5 of 3.5 s, Type B, two trips, in the 2016 to 2019 hybrid tables; above 159 °C, Type A, one trip, in another 2019 table; above 130 °C, Type A, on the 2011 Volt; above 125 °C, Type B, on the 2011 and 2013 two-mode trucks. A genuine overheat is reported separately as an over-temperature code such as P0A3D or P0C14. Because the sensor sits inside the inverter, the fix is usually the inverter assembly.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / F4

Possible causes

  • Shorted sensor or circuit inside the power inverter module high
  • Sensor signal shorted to ground in external wiring, where present medium
  • Moisture or coolant inside the inverter housing low

Symptoms

  • Malfunction indicator lamp and hybrid warning
  • Motor B power strongly limited
  • Reduced hybrid assist and regeneration

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0AF4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication