P0AF3
Drive Motor Inverter Temperature Sensor B Circuit Range/Performance
P0AF3 is the plausibility test for inverter temperature sensor B, the phase U sensor of GM's motor B inverter. In the 2016 to 2019 tables the sensor is compared after a cold soak with a calculated average vehicle temperature; a difference above 20 °C sets the code, Type B, two trips. The 2011 Volt compares it with the other power electronics sensors at 20 °C, Type A, and the 2011 and 2013 two-mode trucks after 360 minutes off at 15 °C, Type B. GM bulletin PIC6303A lists P0AF3 with P0AEE and the other inverter thermistor codes on 2016-18 Volt, Malibu, LaCrosse and Regal with the 5ET50 drive: alone they cause no noticeable effect, and the inverter is replaced only if P0AC4 set at the same time.
Possible causes
- Inverter temperature sensor B drifting out of tolerance medium
- Failing power inverter module medium
- Uneven inverter coolant flow after soak low
Symptoms
- Malfunction indicator lamp after two trips
- Often no noticeable drivability change
- Further inverter temperature codes may be stored
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0AF3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.