P0AF2
Drive Motor Inverter Temperature Sensor B Circuit
Inverter temperature sensor B is, in GM's hybrid tables, the phase U thermistor of the second inverter, the one that drives motor B in two-motor systems. P0AF2 is its general circuit code for an electrical fault that the controller does not narrow down to low, high or erratic. No manufacturer documents this exact code publicly; GM's tables report the specific siblings P0AF3, P0AF4 and P0AF5 instead. CARB requires monitoring of hybrid components and their sensor circuits. Without a valid temperature the controller cannot protect the power switches of inverter B and usually limits that motor's torque. Whether a vehicle uses sensor B at all depends on its layout, so read the full code list and check the inverter connectors.
Possible causes
- Internal fault of the sensor inside the power inverter module high
- Corroded or loose connector at the inverter module medium
- Software fault in the motor control processor low
Symptoms
- Hybrid system warning or check engine lamp
- Reduced electric drive or generator power
- Higher fuel consumption in hybrid operation
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0AF2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.