OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0AED

Drive Motor Inverter Temperature Sensor A Circuit

The inverter of an electric drive motor carries thermistors near its power switches so the controller can derate before the IGBTs overheat. In GM's hybrid tables, inverter temperature sensor A is the phase U sensor of the inverter for motor A. P0AED is the general circuit code for it, used for an electrical fault that is not classified as low, high or erratic. No manufacturer documents this exact code publicly; GM reports the specific siblings P0AEE, P0AEF and P0AF0 instead. CARB requires monitoring of hybrid components and their sensors for circuit faults. Without a valid inverter temperature the controller has to assume the worst and usually limits motor torque. The sensor is built into the power inverter module, so repair often means replacing that unit.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / ED

Possible causes

  • Internal fault of the sensor inside the power inverter module high
  • Corroded or loose connector at the inverter module medium
  • Software fault in the motor control processor low

Symptoms

  • Hybrid system warning or check engine lamp
  • Reduced electric drive power
  • Possible loss of electric drive

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0AED

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication