OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0AEA

Hybrid/EV Battery Temperature Sensor D Circuit Low

P0AEA means the voltage of battery temperature sensor D is below its valid range. GM uses NTC thermistors with a pull-up on the sensing board, so a low voltage reads as an extremely hot cell, usually from a short to ground. Thresholds vary: above 160 °C in 8 of 10 samples in the 2016 and 2019 tables; above 95 °C in 30 of 40 on the 2011 and 2013 two-mode hybrids; below 0.3 V, about 90 °C, in 7 of 10 in the eAssist table 13OBDG05C; above 87.5 °C for 1.4 s within 2 s in a 2018 controller. All are Type B, two trips. Volt bulletin 18-NA-342 lists P0AEA among codes that can set falsely and calls for a software update first. A genuinely hot pack would trip lower limits earlier, so treat it as electrical.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / EA

Possible causes

  • Sensor D signal wire shorted to ground high
  • Temperature sensor D internally shorted medium
  • Outdated controller software (GM Volt, bulletin 18-NA-342) medium
  • Moisture or damage on the battery sensing board low

Symptoms

  • Malfunction indicator lamp after two trips
  • Charge and drive power strongly limited
  • Battery cooling running more than usual

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0AEA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication