P0AE1
Hybrid/EV Battery Precharge Contactor Circuit
Before the main contactors close, a precharge contactor routes battery current through a resistor so the inverter capacitors fill slowly instead of drawing a damaging inrush. P0AE1 is the general fault of this precharge path when it is not split into stuck closed (P0AE2), stuck open (P0AE3) or a driver fault (P0AE4 to P0AE7). Honda lists P0AE1 as a bypass contactor malfunction in bulletins 20-030 (2012-15 Civic Hybrid) and 20-021 (2013 ILX Hybrid); there a cracked solder joint in the motor power inverter is the cause and the whole inverter is replaced. Mercedes-Benz names P0AE173 on the G 580 with EQ technology after unplugging the AC charger too early. Expect no ready mode or no charging.
Possible causes
- Defective solder joint in the motor power inverter (Honda IMA) high
- Precharge contactor or precharge resistor failed medium
- Fault logged by battery controller software after an interrupted charging sequence low
- Wiring or connector fault in the contactor circuit low
Symptoms
- Hybrid or EV system warning in the cluster
- Vehicle does not become ready to drive
- Charging not possible
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0AE1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.