OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0ADF

Hybrid/EV Battery Negative Contactor Control Circuit Low

P0ADF reports that the drive circuit of the negative main contactor is pulled too low, typically a short to ground in the coil line. GM documents the code in its 2016-19 hybrid tables: control voltage below 5.35 V while the contactor is commanded on, 13 of 16 samples at 12.5 ms (20 of 25 in one 2016 group), Type B with two trips, enabled above about 9 to 10 V on the 12 V system. CARB 1968.2 requires this kind of circuit monitoring for hybrid outputs. Counterparts are P0ADD (open), P0AE0 (high) and, on the positive side, P0ADB. As the contactor cannot close properly, the high-voltage system does not come up and the vehicle will not drive or charge.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / DF

Possible causes

  • Coil control wire shorted to ground high
  • Negative contactor coil internally shorted medium
  • Moisture in the battery disconnect unit connector medium
  • Driver in the battery controller defective low

Symptoms

  • Vehicle will not enter ready mode or start
  • Hybrid or EV warning light and check engine light
  • Charging not possible

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0ADF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication