P0ADD
Hybrid/EV Battery Negative Contactor Control Circuit/Open
The negative main contactor closes the return path of the traction battery; P0ADD reports an open in its coil drive circuit. GM documents the code in parallel to the positive side: tables since model year 2011 detect open load in the HPC2 and store it after two trips; 2016-19 tables evaluate a control voltage between 1.15 and 2.81 V while off, 40 of 50 samples, Type B, and 2019 tables add a coil current check below 194 mA when on. CARB 1968.2 covers this circuit monitoring of hybrid components. Related codes are P0ADF and P0AE0 for low and high, P0AA5 for a contactor stuck open, P0AD9 for the positive side. Without this contactor the HV system stays off.
Possible causes
- Open in negative contactor coil or its pigtail high
- Loose or corroded connector at the battery disconnect unit medium
- Broken control wire in the battery harness medium
- Driver in the battery controller defective low
Symptoms
- Vehicle will not enter ready mode or start
- Hybrid or EV warning light and check engine light
- Charging not possible
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0ADD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.