P0AD8
Hybrid/EV Battery Pack Air Flow Valve A Control Circuit High
With P0AD8 the battery controller sees too high a voltage in the drive circuit of air flow valve A, typically a short to a supply voltage or an actuator that no longer draws current. The component is the motorized flap that directs cooling air through an air-cooled traction battery, documented for example in Audi's Q5 hybrid bulletin on the related code P0AD6. No manufacturer publicly documents P0AD8; exact limits are not published. CARB 1968.2 requires circuit monitoring of battery thermal management outputs. Compare P0AD7 for the low side and P0AD5 for an open circuit. The flap may stay in one position, so cooling and electric drive can be restricted.
Possible causes
- Control wire shorted to a supply voltage high
- Actuator no longer loading the circuit medium
- Bridged or bent pins in the connector medium
- Battery controller output stage defective low
Symptoms
- Hybrid warning, electric drive may be switched off
- Check engine light on
- Battery temperature not controlled as usual
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0AD8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.