OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0AD2

Hybrid/EV Battery Pack Cooling Fan 3 Control Circuit Low

P0AD2 reports that the control signal for battery fan 3 is pulled too low, typically a short to ground on the line between battery controller and blower. Such fans are mostly speed-controlled by a PWM duty cycle, as a Toyota patent on battery fan control explains. No manufacturer publicly documents P0AD2; GM sets the analogous fan 1 code P0A84 when the control voltage stays below 0.257 V with system voltage above 9.1 V, Type B with two trips. The open circuit is P0ACF, a short to voltage P0AD3. CARB requires these electrical checks for battery thermal components. Fan 3 then cannot be driven, and the battery may run warm with limited power.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / D2

Possible causes

  • Control wire chafed through to body ground high
  • Internal short in fan 3 motor or its electronics medium
  • Moisture or spilled liquid in the fan connector medium
  • Output stage in the battery controller defective low

Symptoms

  • Hybrid or EV system warning light, often with check engine light
  • Electric drive power reduced when the battery gets warm
  • No fan noise from the battery area when cooling is expected

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0AD2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication