P0ACD
Hybrid/EV Battery Temperature Sensor C Circuit High
P0ACD indicates that battery temperature sensor C reports a voltage above its plausible range, which an NTC sensor translates into extreme cold. Common reasons are an open circuit, a pin backed out of the sensing board connector or a cracked thermistor. GM sets the code below -69 °C in 8 of 10 samples in its 2016 and 2019 tables, below -45 °C in 30 of 40 on the 2011 and 2013 two-mode hybrids, and above 4.63 V, about -45 °C, in 7 of 10 in the 2013 table 13OBDG05C; Type B, two trips. On the Chevrolet Volt, bulletin 18-NA-342 ties it to a false Battery Too Cold message and a reprogramming fix. A seemingly frozen pack is heavily limited in charge and discharge.
Possible causes
- Open signal or return wire of sensor C high
- Thermistor open or cracked medium
- Controller software issue on the Volt (bulletin 18-NA-342) medium
Symptoms
- Check engine or hybrid warning light
- Battery too cold message in mild weather
- Strongly reduced charging and electric power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0ACD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.