OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0ACC

Hybrid/EV Battery Temperature Sensor C Circuit Low

P0ACC sets when the signal of battery temperature sensor C drops below the valid voltage window. For the NTC sensors GM uses, that equals an impossibly hot reading, most often caused by a short to ground in the pack wiring. GM's thresholds for sensor C mirror those for B: above 160 °C in 8 of 10 samples in the 2016 and 2019 tables, above 95 °C in 30 of 40 in the two-mode tables of 2011 and 2013, and below 0.3 V, about 90 °C, in 7 of 10 in the 2013 table 13OBDG05C; always Type B, two trips. Bulletin 18-NA-342 lists P0ACC for the Chevrolet Volt and prescribes a software update first. After that, inspect the sensor C wiring and the sensing board for chafing or moisture.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / CC

Possible causes

  • Sensor C signal shorted to ground high
  • Thermistor shorted internally medium
  • Controller software setting the code falsely (Volt bulletin 18-NA-342) low
  • Moisture at the sensing board connector low

Symptoms

  • Check engine or hybrid warning light
  • Sensor C shows an implausibly high temperature
  • Reduced charging and electric drive power

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0ACC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication