P0ACA
Hybrid/EV Battery Temperature Sensor C Circuit
Battery temperature sensor C is a further thermistor inside the high-voltage pack, corresponding to sensor 3 in GM's Volt bulletin. P0ACA covers a general electrical fault in its circuit that the controller does not narrow down to low, high or erratic. No manufacturer documents this exact code publicly; GM reports the more specific siblings P0ACB to P0ACE instead. CARB requires temperature sensors of hybrid batteries to be monitored like other input components. Losing one temperature input makes the controller more cautious: expect reduced charge and assist power and a hybrid warning. Since sensors C and B often share the same sensing board, check whether neighbouring sensor codes are stored as well.
Possible causes
- Poor contact or damaged wire between sensor C and sensing board high
- Temperature sensor C failed medium
- Fault in the battery controller input stage low
Symptoms
- Hybrid system or check engine warning
- Reduced electric power and regeneration
- Further battery sensor codes may be stored
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0ACA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.