P0AC8
Hybrid/EV Battery Temperature Sensor B Circuit High
P0AC8 reports that battery temperature sensor B delivers a voltage above its valid range, which for an NTC thermistor reads as extreme cold. An open wire, a disconnected sensing board plug or a broken sensor are typical. GM's 2016 and 2019 tables set it below -69 °C in 8 of 10 samples, the two-mode hybrid tables of 2011 and 2013 below -45 °C in 30 of 40, and GM's 2013 table 13OBDG05C above 4.63 V, about -45 °C, in 7 of 10; all Type B, two trips. In the Chevrolet Volt, bulletin 18-NA-342 links such codes to a Battery Too Cold message above -25 °C ambient and prescribes reprogramming. A pack believed to be frozen gets strict charge and power limits.
Possible causes
- Open signal or return wire of sensor B high
- Thermistor open internally medium
- Controller software issue on the Volt (bulletin 18-NA-342) medium
- Signal shorted to the reference voltage low
Symptoms
- Check engine or hybrid warning light
- Battery too cold message although it is not cold
- Strongly reduced charging and electric power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0AC8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.