OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0AC7

Hybrid/EV Battery Temperature Sensor B Circuit Low

P0AC7 means the voltage of battery temperature sensor B is below its valid range. GM's sensors are NTC thermistors, so a low voltage equals an extremely hot reading, usually from a short to ground. The thresholds differ by program: the 2016 and 2019 tables fail it above 160 °C in 8 of 10 samples; the two-mode tables of 2011 and 2013 above 95 °C in 30 of 40 samples; GM's 2013 table 13OBDG05C below 0.3 V, about 90 °C, in 7 of 10. All are Type B, two trips. GM's Volt bulletin 18-NA-342 names P0AC7 among sensor codes that can set falsely and calls for a software update. A genuine hot pack would trip far lower thresholds first, so treat P0AC7 as an electrical fault.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / C7

Possible causes

  • Sensor B signal shorted to ground inside the pack harness high
  • Thermistor shorted internally medium
  • Controller software setting the code falsely (Volt bulletin 18-NA-342) low
  • Moisture or coolant at the sensing board connector low

Symptoms

  • Check engine or hybrid warning light
  • Sensor B shows an implausibly high temperature
  • Charging and drive power reduced

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0AC7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication