P0AC5
Hybrid/EV Battery Temperature Sensor B Circuit
Battery temperature sensor B is one of several thermistors that measure cell or module temperature inside the high-voltage pack; GM's Volt bulletin calls it sensor 2 of nine. P0AC5 is the general circuit code for it, used for an electrical fault the controller does not classify as low, high or erratic. No manufacturer documents this exact code publicly; GM, for instance, reports P0AC6 to P0AC9 instead. CARB requires hybrid battery temperature inputs to be monitored for circuit faults. With one sensor missing the controller has a gap in its temperature picture and tends to limit charge and discharge power. The sensor usually sits on a module or sensing board inside the pack, so checks need high-voltage safety procedures.
Possible causes
- Poor contact or damaged wire between sensor B and sensing board high
- Temperature sensor B failed medium
- Fault in the battery controller input stage low
Symptoms
- Hybrid system or check engine warning
- Reduced electric power and regeneration
- Charging may be slower on plug-in models
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0AC5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.