P0AC2
Hybrid/EV Battery Pack Current Sensor A Circuit High
With P0AC2 the current sensor output sits above its valid window, which after conversion would mean an implausibly large current in the opposite direction to P0AC1. GM's 2016 and 2019 hybrid tables set it when the Hall-effect sensor reads above 274.6 A in 8 of 10 samples taken every 25 ms, again as Type A with immediate MIL. The 2013 table for an earlier pack uses an output above 4.65 V, roughly 215 A, with 7 of 10 samples and Type B. A signal shorted to the 5 V supply or an open sensor ground are common reasons. Because the controller can no longer count charge, it caps battery power; the low limit is P0AC1 and implausible offsets are P0AC0.
Possible causes
- Sensor ground open high
- Signal wire shorted to the 5 V supply or another voltage medium
- Hall current sensor failed internally medium
Symptoms
- Hybrid system or check engine warning on
- Battery power limited, engine runs more often
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0AC2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.