P0AC0
Hybrid/EV Battery Pack Current Sensor A Circuit Range/Performance
P0AC0 belongs to the battery current sensor family, not to battery cooling. It reports a sensor whose reading is electrically valid but implausible. GM's 2011 to 2013 hybrid tables describe the check: with the contactors open, when no current can flow, the reading in each of the sensor's high, mid and low ranges must stay within 5 A of zero, and the controller also checks that the measured current fits the change in pack voltage. A failure sets the code as one-trip Type A in the 2013 table. The check waits while circuit codes P0AC1 or P0AC2 are active. Effects are a drifting charge estimate, reduced hybrid power and, in severe cases, a vehicle that will not go ready.
Possible causes
- Current sensor zero offset drifted high
- Unstable sensor supply or reference voltage medium
- Battery controller input fault low
Symptoms
- Hybrid system or check engine warning on
- State of charge display drifts or jumps
- Reduced electric assist
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0AC0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.