P0ABF
Hybrid/EV Battery Pack Current Sensor A Circuit
The pack current sensor, usually a Hall-effect unit around the main cable, tells the battery controller how much current flows in and out. P0ABF is the general fault of sensor A. GM uses it in its 2019 hybrid controller tables as a stuck-in-range check: before the high-voltage bus is precharged the controller stores a zero-current baseline, then expects a measurable change once precharge starts or the main contactor closes and loads such as the inverter and auxiliary power module draw current. If the reading moves by less than 1 A, P0ABF fails. Out-of-range readings are P0AC1 and P0AC2, offset errors P0AC0. Without a valid current value state of charge cannot be tracked, so power is limited.
Possible causes
- Hall current sensor output frozen high
- Sensor supply, ground or signal wire faulty medium
- Sensor not seated around the conductor after repair low
Symptoms
- Hybrid system or check engine warning on
- Reduced electric power and erratic charge display
- Vehicle may not go ready
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0ABF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.