OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0ABC

Hybrid/EV Battery Pack Voltage Sense A Circuit Low

P0ABC is stored when the pack voltage sensor reports a value below anything the battery could really have, pointing to a short to ground or a lost sense signal rather than a discharged pack. GM's 2016 and 2019 hybrid tables set it below 4.8 V with system voltage above 10.2 V, after 8 failed samples out of 10 taken every 25 ms, and rate it Type A with MIL on the first trip. The 2013 table for an earlier hybrid uses a limit of 30 V, 7 of 10 samples and Type B. A real deep discharge is handled by other codes such as P0AFA. Because the controller no longer trusts pack voltage, hybrid operation is restricted or the vehicle will not go ready.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / BC

Possible causes

  • Sense line shorted to ground or disconnected high
  • Sense fuse or link open so no voltage reaches the input medium
  • Battery controller measurement input defective low

Symptoms

  • Hybrid system or check engine warning on
  • Vehicle may refuse to enter ready mode
  • Engine runs continuously, no electric drive

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0ABC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication