P0AB8
Engine Mount B Control Circuit High
With P0AB8 the controller finds the control circuit of active engine mount B at too high a level, for example because the line has a short to battery voltage or the driver cannot pull it down. Ford names the code in its 2020-23 gasoline OBD summary as the bank 2 high fault of the active-mount circuit check, which runs continuously and needs about 5 seconds of driver-reported fault before a code is stored. Honda's 2008 Pilot uses the B codes for the rear mount actuator. The open circuit is P0AB6, the low side P0AB7, and the mirror code for mount A is P0A16. Consequences are comfort-related: the mount stays in its default state and vibration rises at idle.
Possible causes
- Control wire shorted to a battery-voltage circuit high
- Mount actuator defective medium
- Output driver in the engine controller defective low
Symptoms
- Check engine light on
- Rougher feel at idle and when pulling away
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0AB8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.