P0AB6
Engine Mount B Control Circuit/Open
Some engines sit on switchable or actively driven hydraulic mounts whose solenoid or actuator is energised by the engine controller. P0AB6 reports that the driver output for the second mount (B) sees an open or otherwise faulty circuit. Ford lists the code in its 2020-23 gasoline OBD summary under active mounts, assigns mount B to bank 2, monitors continuously and lets the low-level driver fault mature for about 5 seconds before storing it. On the 2008 Honda Pilot the same code covers the rear mount actuator. Mount A has the matching codes P0A14 to P0A16. Drivers mostly notice more vibration at idle or in cylinder-deactivation mode; the engine itself keeps running normally.
Possible causes
- Broken or chafed control wire to the mount actuator high
- Corroded or loose connector at the mount (splash zone) medium
- Mount solenoid or actuator coil open internally medium
- Output driver in the engine controller defective low
Symptoms
- Check engine light on
- Noticeable vibration at idle or with cylinder deactivation active
- Cylinder deactivation may be suspended on some models
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0AB6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.