P0AB4
Hybrid/EV Battery Pack Air Temperature Sensor B Circuit High
P0AB4 reports a signal from air temperature sensor B above the valid range. For an NTC thermistor that reads as extremely cold air, which points to an open circuit, a broken ground or a disconnected plug. GM uses the code for the outlet air sensor of its full-size two-mode hybrids; the 2011 and 2013 tables set it when the outlet reading falls below -45 °C in 30 of 40 samples, Type B, two trips. With the outlet value rejected, the controller also suspends the outlet plausibility test P0AB2 and runs the fan on a substitute strategy. Look for a connector left off after battery work or a broken wire at the duct. The shorted counterpart is P0AB3, the inlet-side equivalent P0AAF.
Possible causes
- Open signal or ground wire of sensor B high
- Connector not refitted after battery or duct work medium
- Thermistor open internally medium
Symptoms
- Check engine or hybrid warning light
- Outlet air shows about -40 °C in live data
- Battery fan on default operation
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0AB4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.