OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0AAF

Hybrid/EV Battery Pack Air Temperature Sensor A Circuit High

Air temperature sensor A is the thermistor GM places at the cooling air inlet of air-cooled hybrid packs. Being an NTC type, a high signal voltage means the controller sees implausibly cold air, typically from an open wire or a lost ground. GM's 2013 table 13OBDG05C sets P0AAF above 4.63 V, equal to about -45 °C, in 7 of 10 samples; the two-mode hybrid tables of 2011 and 2013 use a reading below -45 °C in 30 of 40 samples. All are Type B, two trips. The controller then ignores the inlet value, so fan control and the inlet-to-outlet comparison lose their reference. Check the connector at the inlet duct for a pushed-out pin first. The shorted counterpart reading as very hot is P0AAE.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / AF

Possible causes

  • Open signal or ground wire between sensor and battery controller high
  • Connector at the air inlet duct loose or with pushed-back pin medium
  • Thermistor open internally medium
  • Battery controller input fault low

Symptoms

  • Check engine or hybrid warning light
  • Scan tool shows inlet air near -40 °C regardless of weather
  • Battery fan runs on a fixed default speed

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0AAF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication