P0AAE
Hybrid/EV Battery Pack Air Temperature Sensor A Circuit Low
The battery air temperature sensor is an NTC thermistor, so a low signal voltage reads as very hot air. P0AAE sets when the signal stays below the lower limit, usually a short to ground. GM's 2013 table (13OBDG05C) uses under 0.3 V, about 90 °C, in 7 of 10 samples; the two-mode hybrid tables of 2011 and 2013 flag an inlet reading above 95 °C in 30 of 40 samples. Both are Type B, two trips. Since the controller then assumes overheated cooling air, it may run the fan hard and cut battery power although nothing is hot. Look for chafed sensor wires touching ground or a sensor shorted internally. The opposite case, an open circuit reading as very cold, is P0AAF.
Possible causes
- Sensor signal wire chafed and shorted to ground high
- Thermistor shorted internally medium
- Battery controller input fault low
Symptoms
- Check engine or hybrid warning light
- Battery cooling fan runs at high speed without reason
- Reduced electric assist and regeneration
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0AAE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.