P0AAD
Hybrid/EV Battery Pack Air Temperature Sensor A Circuit Range/Performance
P0AAD is the plausibility check for battery air temperature sensor A: the signal is electrically valid but does not fit other temperatures. GM documents two methods. In the 2011 and 2013 full-size two-mode hybrid tables, at power-up the inlet air reading may not exceed the outlet air reading by more than 20 °C, checked once per start. In GM's 2013 table (13OBDG05C), after more than 8 hours off the inlet sensor may not differ from the average battery core temperature by more than 10 °C, 50 of 62 samples. Both are Type B, two trips. A sensor stuck at a plausible value, a sensor out of the air stream or a faulty core sensor can cause it. The car keeps running, but fan control and power limits may be wrong.
Possible causes
- Thermistor drifted or stuck at a plausible value high
- Sensor displaced from the air stream or duct blocked medium
- Fault in the comparison sensor (outlet air or cell temperature) low
Symptoms
- Check engine or hybrid warning light
- Battery cooling fan behaves unusually
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0AAD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.