P0AAC
Hybrid/EV Battery Pack Air Temperature Sensor A Circuit
Air-cooled hybrid batteries carry a thermistor in the cooling air path; GM calls sensor A the inlet air sensor. The battery controller uses it to run the fan and to judge cooling. P0AAC is the general circuit code, set for an electrical fault that is not classified as low, high or erratic. No manufacturer documents this exact code publicly; GM reports the siblings P0AAD to P0AAF instead, with Type B, two-trip logic. CARB requires hybrid component temperature sensors to be monitored like other input components. If the controller has no valid air temperature, it typically falls back to fixed fan control and may restrict battery power. Check connector and wiring at the air inlet duct first, then the sensor.
Possible causes
- Loose, corroded or damaged sensor connector or wiring at the air duct high
- Failed air temperature thermistor medium
- Battery controller input or reference voltage fault low
Symptoms
- Check engine or hybrid system warning light
- Battery cooling fan runs constantly or at fixed speed
- Reduced electric assist in hot conditions
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0AAC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.