P0AA7
Hybrid/EV Battery Voltage Isolation Sensor Circuit
To measure isolation, the battery controller reads the voltage of each HV rail against chassis ground through an isolation sensor circuit and can switch in a known bias resistor. P0AA7 means this measuring circuit itself does not work, so the controller can no longer judge isolation. GM's 2016 and 2019 tables use it for a bias switch self-test: with all contactors open for 8 seconds after shutdown, switching the bias resistor must change both sensor readings; a combined change below 5 V squared sets the code, Type B, two trips. Mitsubishi lists P0AA7 to P0AA9 as leak detection circuit faults; on 2018 Outlander PHEVs noise caused false setting and a 60 km/h limit until restart, fixed by a sub-BMU update. P0AA6 is the actual insulation fault.
Possible causes
- Failed isolation bias switch or measuring circuit inside the battery controller high
- Controller software misreading electrical noise (update available on some models) medium
- Open or loose isolation sense lead or connector at the battery low
Symptoms
- Check engine and EV system service warnings
- Power reduced or speed limited until the system is switched off and on
- Regenerative braking warning on some models
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0AA7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.