P0AA4
Hybrid/EV Battery Negative Contactor Circuit Stuck Closed
P0AA4 reports that the negative main contactor still conducts while it should be open, usually through welded contacts, so the pack is no longer fully isolated on the negative side. GM tests it once all contactors have been commanded open for more than 120 s, or the bus has already decayed below 9 % of pack voltage: over 30 V on the negative bus in 4 of 6 samples at 12.5 ms sets Type B (two trips, 19OBDG02). GM's 2017 Bolt EV bulletin prescribes contactor cycling and then a new battery disconnect unit; the 2019 Volt update links welded contactors to P0AA1, P0AA4 and P0C76. Jeep cures false sets on the 2023 Grand Cherokee 4xe by software, and Mitsubishi calls it main contactor (-) seizure on the i-MiEV.
Possible causes
- Negative contactor contacts welded after high current or arcing high
- Battery or hybrid controller software (GM Volt 2019, Jeep 4xe updates) medium
- Faulty battery disconnect unit (GM Bolt EV bulletin) medium
- Negative bus voltage sensing error low
Symptoms
- Vehicle will not start or switch into ready mode
- Check engine light and high voltage system message
- Often stored together with P0AA1 or the slow discharge code P0C76
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0AA4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.