P0AA0
Hybrid/EV Battery Positive Contactor Circuit
The positive main contactor is a high-voltage relay that connects the positive pole of the traction battery to the propulsion bus. P0AA0 is the general fault code for this contactor circuit, used when the controller sees a problem it does not split into stuck closed (P0AA1), stuck open (P0AA2) or the control-circuit codes P0AD9 to P0ADC. No manufacturer documents this exact code publicly; GM, Audi, Jeep and Mitsubishi report the specific siblings instead. NHTSA's Mach-E recall query shows the underlying failure modes: overheated contacts that stay open or weld shut. With the positive side unusable the car may refuse ready mode or drop propulsion; work on it requires high-voltage qualification.
Possible causes
- Positive contactor or battery junction box worn or damaged high
- Fault in the contactor coil feed or its connector medium
- Weak 12 V supply so the contactor does not pull in reliably low
Symptoms
- Vehicle does not enter ready or propulsion-active mode
- Hybrid or EV system warning with check engine light
- Possible loss of propulsion while driving
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0AA0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.