P0A9F
Hybrid/EV Battery Temperature Sensor A Circuit Intermittent/Erratic
Cell temperature changes slowly, so a reading that jumps back and forth points to the circuit, not the battery. GM monitors this by summing the absolute sample-to-sample change of sensor A over a 10-sample window every 100 ms; if the sum exceeds 10, that window fails, and four failed windows out of five set P0A9F as Type B (two trips) in the 2016 and 2019 hybrid tables (16OBDG02, 19OBDG02). GM names a loose or intermittent connection as the typical trigger. The signal may still sit inside its valid range, which separates P0A9F from the hard low/high codes P0A9D/P0A9E and from the plausibility code P0A9C. The car protects the pack by limiting power and may show the fault only now and then.
Possible causes
- Loose, fretted or corroded pin in the sensor connector high
- Partly broken sensor wire that opens with vibration or heat medium
- Electrical interference on the sensor line from high-voltage components low
Symptoms
- Warning light that comes and goes
- Temporarily reduced hybrid or EV power
- Battery temperature value jumps in the scan tool data
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A9F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.