OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0A9E

Hybrid/EV Battery Temperature Sensor A Circuit High

With the NTC thermistor of sensor A on a pull-up circuit, an open sensor or wire drives the input voltage toward the reference, which the controller reads as an extremely cold cell. GM sets P0A9E (Type B, two trips) when the value falls below -69 °C in 8 of 10 samples (19OBDG02); Two-Mode hybrids flag readings below -45 °C, other programs below -40 °C for 1.4 s. GM's Volt bulletin 18-NA-342 lists it as sensor 1 circuit high voltage and pairs it with a battery too cold message at mild ambient temperatures. Unlike P0A9D the fault suggests an open circuit rather than a short. Because cold cells accept little current, the car restricts charging, regeneration and electric drive.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / 9E

Possible causes

  • Open sensor wire or unplugged connector inside the pack high
  • Open (failed) thermistor on the sensing board medium
  • Signal shorted to the reference voltage low
  • Battery controller software causing false sets (GM Volt) low

Symptoms

  • Check engine or hybrid warning light
  • Battery too cold message although it is not cold
  • Little or no electric drive and weak regeneration

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0A9E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication