OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0A9D

Hybrid/EV Battery Temperature Sensor A Circuit Low

Sensor A is an NTC thermistor fed through a pull-up resistor, so the voltage falls as the temperature rises; a short to ground looks like an absurdly hot cell. GM sets P0A9D (Type B, two trips) when the converted value exceeds 160 °C in 8 of 10 samples (19OBDG02); Two-Mode hybrids use above 95 °C while the other sensors read below 70 °C, other programs above 87.5 °C for 1.4 s. GM's Volt bulletin 18-NA-342 names it sensor 1 circuit low voltage. The low-voltage case is the counterpart of P0A9E (open circuit, reads very cold) and differs from P0A7E, which reports a real overtemperature. Because the controller must assume heat, it cuts charge and discharge power and may run cooling at full speed.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / 9D

Possible causes

  • Sensor signal wire shorted to ground or chafed inside the pack high
  • Internally shorted thermistor on the sensing board medium
  • Moisture or coolant in the sensor connector low
  • Battery controller software causing false sets (GM Volt) low

Symptoms

  • Check engine or hybrid warning light
  • Strongly reduced electric power or no EV mode
  • Battery cooling running at high speed without reason

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0A9D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication