P0A9B
Hybrid/EV Battery Temperature Sensor A Circuit
Temperature sensor A is one of the thermistors the battery controller uses to track cell or module temperature for cooling, charge limits and power limits. P0A9B is the general circuit code for this sensor: the controller finds an electrical fault it does not classify further as low, high or erratic. No manufacturer documents this exact code publicly; GM, for example, reports the sibling codes P0A9C to P0A9F instead. In those tables a failed sensor input is excluded from protection logic, and GM's Volt bulletin notes several sensors per pack. Expect a hybrid warning and reduced charge and assist power while the controller works with fewer valid temperatures. Check the sensor harness at the module sensing board before condemning the pack.
Possible causes
- Open, corroded or loose sensor wiring or connector inside the pack high
- Failed thermistor on the module or cell sensing board medium
- Battery controller input or software fault low
Symptoms
- Hybrid or EV system warning and check engine light
- Reduced electric assist, regeneration or charging power
- Battery cooling fan or pump runs more than usual
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A9B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.