P0A86
14 Volt Power Module Current Sensor A Circuit
The 14 volt power module is the DC/DC converter that feeds the 12 V network of a hybrid or electric vehicle from the high-voltage battery; GM calls it the Accessory Power Module (APM). Current sensor A measures the current flowing through this converter. P0A86 is the general circuit code for that sensor, used when the controller recognises a fault in the sensor circuit without classifying it as low, high, implausible or intermittent (P0A87 to P0A8A). No manufacturer documents this code publicly; GM's published tables for the same APM input sensor use only the low/high codes P0A88 and P0A89. With an untrustworthy current reading the hybrid controller may limit or switch off the converter, so the 12 V battery can run down over time.
Possible causes
- Current sensor inside the 14 V power module faulty (usually not replaceable separately) high
- Damaged wiring or corroded connector between module and hybrid controller medium
- Software fault in the module or hybrid controller low
Symptoms
- Hybrid or charging system warning lamp on
- 12 V battery discharges, low-voltage warnings
- Possibly no other noticeable change in driving
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A86
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.