P0A84
Hybrid/EV Battery Pack Cooling Fan 1 Control Circuit Low
The controller detects a short to ground on the control output of battery cooling fan 1. GM tests it while the fan is commanded at low duty: a circuit voltage below about 0.26 V counts as a failure, and 16 fails in 20 samples at 250 ms set a Type B code (MIL after two trips). Another GM hybrid program detects it through the output stage status flag (20 of 25 samples). Mitsubishi lists P0A84 in the BMU and PHEV ECU of the 2018–20 Outlander PHEV among codes caused by a frozen battery heater relay, so meaning can differ by maker. Open and high faults are P0A81 and P0A85. With the output pulled low the fan may not respond, the pack warms up and power can be reduced.
Possible causes
- Fan control wire chafed and shorted to ground high
- Internal short in the fan's control input medium
- Moisture or corrosion in the fan connector low
- Defective output stage in the controller low
Symptoms
- Check engine or hybrid warning after two trips
- Battery cooling fan does not follow commands
- Reduced hybrid power when the pack gets warm
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0A84
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.