P0A70
Generator Phase U Current Low
P0A70 means phase U of the hybrid generator carries or reports too little current while the generator is loaded, typical of an open phase or a sensor stuck near zero. No manufacturer documents P0A70 publicly. The closest published test is GM's open-phase check for the drive motors (P0A67 and siblings), which compares the peak current near each phase axis against a 9 A threshold; GM publishes no such test for the generator. A Caterpillar patent identifies a failed phase sensor by a reading close to zero while the currents no longer sum to zero. CARB requires circuit monitoring of electric drive components. P0A71 is the high side, P0A73 and P0A76 phases V and W, P0A6F the general code. Engine start and charging can be affected.
Possible causes
- Open circuit in the generator phase U lead or terminal high
- Generator phase U current sensor stuck near zero medium
- Phase U switch in the generator inverter not conducting medium
Symptoms
- Hybrid warning and MIL
- Engine runs rough at start or battery charge level keeps dropping
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A70
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.